Hi Hanward,
It is a Li-ion or Li Poly battery 3.7v
The space that it fits in space that is 35mm x 23mm and the battery thickness must not exceed 8mm.
I’m looking for about 600mAh, but for that size I expect we will get around 300mAh.
In the future we might be able make the space bigger so I also need some samples of batteries that can fit in a space
That is 23mm x 50 mm and a thickness not exceeding 8mm.
These batteries are supposed to fit on the MechPump Daughter board where it says BT1 and BT2
If the batteries come with connectors then, please get me the PCB side too, which is this molex connector I believe.
Please check that the polarities are correct.
Regards
Neal
What kind of battery? is there any picture? and the capacity?
Thanks and Best Regards!
Hanward Jiang General Manager
------------------------------------------------------------------------------------------------------
Shenzhen Cirket Electronics Co.,Ltd
Add.:3F,Block B1,HengFeng Ind.Zone,Hezhou,Xixiang,BaoAn,Shenzhen, Guangdong, 518128, P.R.China
<a href="tel:+86-755-8621">Tel: +86-755 27364707(8006) Mobile: +86 13510501306
Wechat:148092983 Skype: hanward
http://www.szckt.cn/ Email: [hidden email]
-------------------------------------------------------------------------------------------------------
Subject: Batteries and their Specs
Hi Hanward,
Here are the samples I needed from that Company but they don’t have stock of the LP502522 (size is important for this one and the LP412030 it cannot be bigger than 35x23mm))
LP502522 x 10
LP412030 x 5
LP403040 x 2
LP453048 x 2
Best Regards
Neal Singh
082 4593467
Ph: 011 615-3437
www.smartfuel.co.za