Master Controller -How to Erase the Code and the FRAM

[NEAL SINGH]

Erase the Code / Erase Code

Jumper across P1

 

Erase the FRAM (setup) / Erase FRAM

There are two ways

1. Use Switch S1

1. Set DW1 = High and DW2 = Low (while power ON)
2. Hit the reset
3. While the White Error Flashing is Flashing (does so for 5Seconds)
4. Set DW2 High and then Low (toggle it)
5. Set DW1 Low

 

2. Issue this command 3 times